Item GBD334400SC is well suited for honing. See more info below.

CP Pistons Cylinder Honing Recommendation (for CPN & CPN2)
For use with CP's CPN and CPN2 piston rings, we recommend plateau
honing with a cylinder bore cross hatch angle of 35-40°.

To reach this roughness, the manufacturers of honing machines and accessories
recommend using for a gray cast iron engine block, and Nikasil cylinders:

- Conventional stones #220 - #280 grit or
- Diamond stones # 325 - #550 grit

After honing, with either conventional or diamond stone, the same
manufacturers suggest to finish your honing by smoothing the surface
with a fine grit conventional abraisive (#400 - #600 grit) or to sweep the
bores with a flexible brush or a nylon bristle plateau honing tool. This is
necessary to get rid of jagged peaks and folded or torn material.

IMPORTANT NOTE:
Be sure to confirm with your honing equiment manufacturer that the recommended
stone grit will produce the following Rz and Ra roughness recommendations:

Rz = 59 - 138 µ in (=1.5 - 3.5 µm) or
Ra = 15 - 35 µ in (=0.4 - 0.9 µ m)

Recommendations for installation.
Further recommendations.